Verint NEXTIVA S2800E series Betriebsanweisung PDF herunterladen (Seite 29)

Nextiva S2800e Series Programming Guide Supported Protocols • 23

Supported Protocols

The S2800e provides the ability to work with protocols from other manufacturers. This section briefly

describes the use of the onscreen menu system with these specific protocols. Before using these protocols,

DIP switch SW2 must be set to the appropriate protocol.

1. Set switch 1 on DIP switch 2 (SW2) to the appropriate video mode (PAL/OFF or NTSC/ON).

2. Set switch 2 on DIP switch 2 (SW2) to the OFF position (SERIAL).

3. Set switch 3 on DIP switch 2 (SW2) to the appropriate communication mode (SIMPLEX or DUPLEX).

4. Set switch 4 on DIP switch 2 (SW2) to the appropriate communication protocol (RS-422 or RS-485).

5. Set switches 5-8 on DIP switch 2 (SW2) to the appropriate manufacturer protocol.

Supported Protocol Switches 5-8:

• Pelco: Switch 5 is ON, switches 6-8 are OFF (set switch 3 to ON for 2400 baud keypad)

• Sensormatic: Switch 6 is ON, switches 5, 7, 8 are OFF

• Philips: Switch 7 is ON, switches 5, 6, 8 are OFF

• Kalatel: Switches 6 and 7 are ON, switches 5 and 8 are OFF

• Panasonic: Switches 5 and 8 are ON, switches 6 and 7 are OFF

• NTCIP: The dome is specifically coded from the factory or flash upgraded. It cannot be switched to

other protocols without first flashing the firmware back to standard factory protocol. Switches 5-8 are

not used and switch 3 must be OFF for Duplex.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34

Keine Kommentare

Verint NEXTIVA S2800E series Betriebsanweisung Seite 29