Verint NEXTIVA S2800E series Betriebsanweisung PDF herunterladen (Seite 25)

Nextiva S2800e Series Programming Guide Programming the S2800e Camera • 19

• Motion Detection – The 23X/35X (day/night) cameras provide

motion detection capability. For each preset, there are six

programmable zones for motion detection with three sensitivity

levels. Programmable actions may be associated with each

detection zone, including calling another preset, turning a relay

on or off, and calling a tour or autotour. For motion detection to

operate, the preset must be solved.

Note: On 35X models, image stabilization (described on page 8) must

be disabled to use motion detection.

1. Go to the Relay Driver menu, then set the Power On State to ON

and the Output Type to MOMENTARY.

2. In Nextiva Control Center, configure the dry contact input of the

S2800e camera. For more information, refer to the “Devices”

chapter in the Nextiva Administrator Guide.

3. Select Motion Detection from the menu for the Preset number to

be set.

4. Enable the motion detection Mode.

5. Select the Motion Area to be programmed (1-6). Press Enter to

set the area. (Screen will revert back to menu.)

6. Select the desired Sensitivity Level (Low, Medium, High) (Off is

the same as Disabled).

7. Select Action then press the Enter key. Select TURN ON AUX,

then press the Enter key.

8. In the IntelliFlow workspace in Nextiva Control Center, create a

new scenario with the Triggers a response when an event

occurs template and the Digital Input Pin event.

When multiple zones are set up, each one is displayed. Those already

set are blue; the current zones to be programmed are red. After Motion

Detection is set for a particular preset position, whenever that preset is

solved and there is motion in that area, the camera dome will perform

the programmed Action. If different actions are set for the same preset

number, multiple actions will take place. For example, a preset can be

solved for Area 1 and an AUX can be turned on for Area 2

simultaneously. If the user attempts to move the camera while motion

detection is enabled and the preset solved, the dome will hesitate a

second to turn off motion detection before it moves.

Warning: Motion detection should not be enabled on a camera that

has physical vibration indicated on the video.

The Program Auto Home allows configuration of the auto home

function. The dome can be set to automatically go to a programmed

preset number location after a programmed time duration of no activity

on the dome has occurred. In addition, the dome can be set to go to its

home position upon power-up.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 33 34

Kommentare zu diesen Handbüchern

Keine Kommentare

Verint NEXTIVA S2800E series Betriebsanweisung Seite 25

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitskameras Verint NEXTIVA S2800E series